Address + directions

GTech Automatisierungstechnik GmbH

Gewerbestraße 6
4551 Ried im Traunkreis
Austria

T. +43 (0)7588 61992-0
F. + 43 (0)7588 61992-104
E. office@gtech.at

Contact persons »
Group & participations »
Legal & GTC »

Career 

Your next step!

"One person waits for the times to change,
the other seizes the day and acts" (Dante)

If you are also one of those people who
prefer action to complacency,
you might find the right challenge
in our company!

read more...

As one of the leading providers of measuring, straightening and testing equipment, we design and manufacture individual measurement and straightening systems for our customers, for the most diverse components and their quality characteristics. These guarantee 100% quality control and permit manual or automatic straightening of the areas of components which have been affected by the heat treatment process, so that the required tolerances are reached again.

The measured values are recorded via high-precision measuring technologies such as tactile measuring probes or visual measuring systems.

All employees handling measuring, straightening and testing technology are prepared and trained for the high requirements of the specific standards via targeted quality training workshops. The service we offer our customers includes performing measurement system analyses acc. to procedure 1, 2 & 3 (VDA Vol. 5) incl. submission of the appropriate test record!

Manually

Our manual measuring and straightening systems are also increasingly used for small quantities or also in the start-up phase of a new product. Individually tuned straightening tools and live measurement during straightening enable the operator to straighten any warp on the component manually within a very short time, thus reaching the tolerances required.

Automatically

Our automatic measuring and straightening systems are used as standalone systems with manual loading and unloading, as well as fully interlinked within production processes. Thanks to an individually developed, learning measuring and straightening software combined with hydraulic local or even 3D straightening tools, we guarantee our customers consistent and constant quality results.

Factbox

 

manual

automatical

Cycle times

worker-dependent

~ 40 sec.*

Straightening

manual straightening tools

hydraulic straightening tools

Measuring

tactile measuring probes
laser sensor

tactile measuring probes
laser sensor

Pros

flexible straightening areas
less capital expenditure

 
flexible assembly space for process units

Cons

worker-dependent quality result

restrictions regarding subsequent expansion

Implemented components

rear doors
side doors
rear strut mountings
side members

rear strut mountings
side members
panels
cross members

All this information provides only an overview of plants implemented by us so far, but we will be pleased to examine any deviating requirements at your end!

*Cycle time in case of 2 straightening cycles of a rear strut mounting with 25 measuring points and 5 straightening areas.